Using Bluelight Throughput Test Mode testing the maximum available network bandwidth between any two points across the network is easy and intuitive .

The typical test setup is as follows.



The first key point here is the TX and RX settings on the local and remote testers must exactly match with each other.


Secondly the local and remote testers must run the measurements under the Throughput Test Mode at the same time.

Now you will get the test results similar to below depending on your actual settings.


(Note: If you conduct a throughput test at the same physical location, you can also only use one tester with both port 1 and port 2. The test setup is exactly the same as above.)

About PlexNet

PlexNet is a dynamic company providing technical services and solutions to the Australian ICT marketplace.

The company’s founders have over 38 years of combined technical and sales experience. This ensures PlexNet is more than able to meet the needs of its current and prospective clients.

Over the last 18 years we have worked closely with many vendors and technology solutions and this experience defines what PlexNet is today. The demands of the IT and data communications industry across the Australian and global marketplace are constantly changing and we are fully cognisant of these changes and welcome the challenges they present

With major global partners such as Colasoft, Edge Technologies, ExtraHop, Infoblox, Nyansa, NETSCOUT, ProfiTap, Spirent Communications and Virtual Instruments, and well supported by a number of other partners, PlexNet has an unparalleled solution and skill set.

Make Contact